Tesamorelin / Ipamorelin Blend — Complete Dosing Protocol & Guide

Tesamorelin / Ipamorelin Blend is a muscle growth peptide — the muscle growth category covers gh boosting, strength, body composition. Combines tesamorelin (a GHRH analog that specifically reduces visceral fat) with Ipamorelin (a clean GHRP pulse trigger) — targets belly fat while amplifying natural GH release. In research settings it is administered subcutaneous at a frequency of once daily (before bed), with an elimination half-life of ~30 min (tesamorelin) + ~2 hr (Ipamorelin) and a studied dose range of 1.2 mg–2.5 mg per administration (about 18 mcg/kg of body weight).

Combines tesamorelin (a GHRH analog that specifically reduces visceral fat) with Ipamorelin (a clean GHRP pulse trigger) — targets belly fat while amplifying natural GH release. That mechanism places it in the muscle growth category. Pharmacokinetically, its elimination half-life of ~30 min (tesamorelin) + ~2 hr (Ipamorelin) is what shapes the once daily (before bed) dosing cadence used in research protocols, and the full effect builds across a 8-12 weeks cycle followed by 4 weeks off — which is why the dosing is cycled rather than continuous.

Tesamorelin / Ipamorelin Blend is taken subcutaneous — subcutaneous injection into abdominal fat is the standard research route. The research-standard frequency is once daily (before bed), with a half-life of ~30 min (tesamorelin) + ~2 hr (Ipamorelin). Research protocols time it before bed, when the natural GH/sleep window amplifies its effect. Always start at the low end of the dose range, use aseptic technique for injections, and follow the 8-12 weeks cycle followed by 4 weeks off. PeptideWise calculates the exact dose and schedule for your body weight and goal.

Research protocols use 1.2 mg–2.5 mg per administration, weight-based at roughly 18 mcg/kg of body weight, administered once daily (before bed). For an 80 kg (176 lb) adult that works out to about 720 mcg for a beginner, 1.1 mg for an intermediate, and 1.4 mg for an advanced research protocol. Start at the bottom of the range and titrate up only while the response is tolerable — the personalized protocol engine on this site computes the exact figure for your weight.

The standard research cycle is 8-12 weeks, followed by 4 weeks off. Cycling matters because continuous exposure leads to receptor desensitization (tachyphylaxis) — the same dose produces less effect over time — and side effects fade during off periods. Don't extend the cycle past 8-12 weeks chasing diminishing returns.

Yes. Tesamorelin / Ipamorelin Blend is commonly researched alongside Sermorelin. The best stacks pair peptides that act through different mechanisms toward the same goal — for example BPC-157 (angiogenesis) with TB-500 (cell migration). Introduce one peptide at a time, align cycle lengths, and cap stacks at 2–3 peptides so effects stay attributable. The protocol engine on this site only recommends stack combinations that pass safety screening for your conditions and medications.

Reported in research and trial settings: water retention; injection site reaction; mild joint pain; flushing. Most are dose-dependent and resolve when the dose is reduced or the cycle ends. If any severe reaction occurs (chest pain, severe abdominal pain, difficulty breathing, signs of an allergic response), stop immediately and seek medical evaluation.

Tesamorelin / Ipamorelin Blend carries a good research safety profile at the doses described above, but safety is individual. It is contraindicated in research settings with: cancer, active tumor, pregnant, breastfeeding, untreated thyroid disorder, diabetes, carpal tunnel. It is not medical advice to run any peptide without supervision — consult a qualified healthcare provider who knows your full history first, get baseline labs, and re-check during the cycle. 🏋️ As a muscle growth peptide, Tesamorelin / Ipamorelin Blend is sold for research use only.

Tesamorelin / Ipamorelin Blend is sold by research-chemical suppliers for laboratory research use only — it is not an approved dietary supplement or consumer product, and regulations vary by country and jurisdiction. Before considering any source: (1) consult a licensed healthcare provider about medically supervised options, (2) if purchasing for research, verify third-party certificates of analysis (COA) confirming purity and identity, and (3) be wary of prices that look too good to be true — they usually are. PeptideWise does not sell peptides; we provide dosing research and protocol tools.

Tesamorelin / Ipamorelin Blend ships lyophilized (freeze-dried) and must be reconstituted before use. Use bacteriostatic water: inject it slowly down the inside wall of the vial (never directly onto the powder), then swirl gently — never shake, as shaking denatures the peptide. Example: a 5 mg vial + 2 mL of bacteriostatic water gives 2.5 mg/mL, so a 250 mcg dose is 10 units (0.1 mL) on an insulin syringe. Store the reconstituted vial refrigerated at 2–8°C and use within 2–4 weeks. See the full step-by-step reconstitution guide for concentration math and storage.